- 3-pin plug
- About 2 kW The portable cable that came with the car
- Wall charger, single phase
- 7.4 kW At least 3x faster, per EECA
- Extension leads
- Don't Listed as unsafe in WorkSafe's guidance
Plenty of New Zealand EV owners never install a charger. They plug the cable that came with the car into a garage socket and it does the job. That works, within limits. Here is what those limits are, and the habits that turn a convenient setup into a fire risk.
Is it safe to charge an EV from a normal socket?
It can be, with the right cable and a sound socket. The portable cable that comes with the car (called Mode 2 charging) has a control box in the lead with built-in protection, and WorkSafe's guidelines allow it at home. The risk is in the socket and wiring: an ordinary power point isn't designed to carry a high current for hours every night, and Evnex notes that repeated plugging and unplugging can loosen the contacts, which causes heat build-up and a risk of melting or fire.
- Use a socket in good condition, ideally one that isn't shared with a freezer, heater or other big load on the same circuit.
- Feel the plug after an hour of charging. Warm is normal; hot, discoloured or smelling of plastic is not. Stop and get an electrician to look.
- Plug in directly, with the cable that came with the car or one from a reputable supplier made for the NZ market.
- If a lot of charging happens on it, have an electrician check the socket and circuit. It costs little and tells you whether the wiring is up to it.
Can I use an extension cord to charge my EV?
No. WorkSafe's electric vehicle charging guidance lists using an extension cord to lengthen the charging cable among unsafe practices. The same list includes socket adaptors, multi-boxes and portable sockets, cascading two or more leads together, charging more than one EV from a single outlet, and modified equipment not made for New Zealand (as summarised by Evnex).
What about a Type 2 extension cable?
Not for normal use. WorkSafe's guidelines say the supply lead to an electric vehicle should be in one piece (section 2.5). A Type 2-to-Type 2 "extension" plugged between your charging cable and the car makes it two pieces, and joining two or more supply leads together is on WorkSafe's unsafe list. If a tethered or untethered cable is too short, buy one longer cable rated for your charger, or have the charger or socket moved closer to where the car parks.
| Option | Allowed? | WorkSafe rule |
|---|---|---|
| Household extension cord on a portable (granny) charger | No | Extension leads are unsafe (1.3 d) |
| Cable reel or a second lead joined on | No | Cascading two or more supply leads is unsafe (1.3 c) |
| Multi-box, double adaptor or portable socket | No | Socket-outlet adaptors and portable socket-outlets are unsafe (1.3 b, e) |
| Type 2-to-Type 2 extension between cable and car | No | Supply lead should be in one piece (2.5) |
| One longer Type 2 cable (e.g. 7.5 m or 10 m) for an untethered charger | Yes | Single lead, rated for the charger |
| New socket or wall charger where the car parks | Yes | Installed by a registered electrician, as close as practicable to the car (2.5) |
Section numbers from WorkSafe's Electric vehicle charging safety guidelines, 2nd edition, read 2 November 2026.
Can I use a 3-pin adaptor or a bigger plug on my portable charger?
Only the plug the maker fitted. WorkSafe says nobody should fit or use any other plug on a portable charger's supply cord, and the cord from the plug to the control box must be 2 m or shorter (sections 3.3 and 3.5). Adaptors between the car and the charger are only allowed if the vehicle or charger maker supplied them for that purpose (3.6). The plug decides the current, and the current decides the speed.
| Plug on the portable charger | Current limit | About |
|---|---|---|
| Standard 10 A 3-pin (AS/NZS 3112) | 8 A, or 10 A with pin temperature sensing | 1.8–2.3 kW |
| Round 16 A plug, blue (IEC 60309-2) | 12 A, or 16 A with pin temperature sensing | 2.8–3.7 kW |
| 20 A plug (AS/NZS 3123) | 16 A, or 20 A with pin temperature sensing | 3.7–4.6 kW |
| UK 13 A plug (BS 1363) | Only if the charger was designed for the UK and still has its original plug | Up to 3 kW |
Current limits from WorkSafe's guidelines, section 3.5. kW is our arithmetic at 230 V (amps × 230), so treat it as a guide. A 16 A or 20 A plug needs a matching socket, which a registered electrician installs.
How fast does a 3-pin plug charge an EV?
About 2kW, which is slow. EECA says a smart wall charger is at least three times faster than a 3-pin plug. In practice, overnight on a 3-pin plug tops up a typical day's commuting, but it won't fill a large battery from low, and it can't keep up if you drive long distances on consecutive days.
| Option | Power | Best for |
|---|---|---|
| Portable cable in a 3-pin socket | About 2 kW | Plug-in hybrids, low mileage, occasional use, holidays |
| Wall charger, single phase | 7.4 kW (32 A) | Daily driving; almost every NZ home |
| Wall charger, three phase | 11–22 kW | Only if you have three phase and the car accepts it |
Speed comparison from EECA. See single phase vs three phase.
Why doesn't EECA recommend 3-pin charging long term?
EECA describes the 3-pin plug as the basic charger that often comes with your EV and says it is not recommended on a long-term basis. Its case for a smart wall charger is that it is faster, safer to use in your home, and can be scheduled into the cheapest off-peak hours automatically. A smart charger can also balance its load against the rest of the house, so it doesn't overload the supply when the oven and heat pump are on.
Is it worth installing a wall charger?
If the EV is your main car, usually yes. You get a dedicated, protected circuit built for hours of continuous load, a tethered cable that stays on the wall, and charging that fits into the off-peak window. If you drive a plug-in hybrid or very few kilometres, the portable cable may be all you ever need, as long as the socket is sound and you never use an extension lead.
Our cost guide has what a home install costs in New Zealand, and the charger packages show what a standard install covers. The fixed price comes from five photos.
Frequently asked questions
Can I charge my electric car from a normal plug in NZ?
Yes, with the portable cable that came with the car plugged straight into a sound 3-pin socket. It charges at about 2kW, and EECA doesn't recommend it as a long-term setup.
Is it safe to use an extension cord for EV charging?
No. WorkSafe's EV charging guidance lists using an extension cord to lengthen the charging cable as an unsafe practice, along with socket adaptors and multi-boxes.
What kind of extension cord can I use for an EV charger?
None. In New Zealand WorkSafe lists any extension lead, and joining two leads together, as unsafe for EV charging, whatever its rating. If the cable won't reach, use one longer charging cable or get a socket or wall charger installed where the car parks.
Can I use a Type 2 extension cable?
Not for normal use. WorkSafe's guidelines say the supply lead to the car should be in one piece, so a Type 2-to-Type 2 extension added to your cable doesn't meet them. Buy a single longer Type 2 cable instead.
Can I put a 15 amp plug on my granny charger?
No. WorkSafe says a portable charger should only use the plug its maker fitted. If you want faster portable charging, buy a charger made with a 16 A or 20 A plug and have an electrician install the matching socket, or install a wall charger.
Can I charge my EV from an outdoor power point?
If it's in good condition, weatherproof and on a sound circuit, it can be used with the car's portable cable. Have an electrician check it if it'll be used most nights.
Why does my EV plug get hot?
Standard sockets aren't designed to carry high current for hours, and worn contacts make it worse. Hot or discoloured plugs are a warning sign: stop using that socket and get an electrician to check it.
Do I need a wall charger for a plug-in hybrid?
Often not. A plug-in hybrid's smaller battery fills overnight from a 3-pin socket. A wall charger makes more sense for a full EV used every day.
Can my employer's EV be charged at home on a 3-pin plug?
WorkSafe's January 2026 addendum discourages charging employer-owned EVs at home on Mode 2 portable cables, because it relies on home wiring the employer doesn't control. Check your employer's policy.
Sources
- EECA, Smart EV chargers
- WorkSafe, Electric vehicle charging safety guidelines
- WorkSafe, Electric vehicle charging safety guidelines, 2nd edition (May 2019), sections 1.3, 2.5, 3.3 to 3.6 (PDF, read 2 November 2026)
- WorkSafe, Addendum to the Electric vehicle charging safety guidelines, 3rd edition (January 2026)
- Evnex, Safe EV charging at home: best practices and tips
- Home Charger NZ, EV charger installation cost NZ (reviewed 31 July 2026)